A technician opens the access panel of a rooftop condenser while a facilities manager beside her holds the service log.

Maintenance contracts · commercial buildings · Rotterdam

Plant kept
in service,
all year round.

A maintenance year

60 minutes on site · €190, credited to year one

The year

What a contract is for

A gloved hand writing in an open service log resting on the top panel of a rooftop condenser, a gauge manifold beside it.

The plant on the roof is the part of the building nobody sees until it fails. When an air handling unit seizes or a chiller drops out in a heatwave, offices overheat, trading stops and repairs become expensive emergencies. This equipment does not need guesswork. It needs steady, scheduled attention from technicians who know how each part behaves across the seasons.

A maintenance contract turns an uncertain year into four or twelve planned visits and one unhurried service log. We check belts, clean condensate drains, verify refrigerant charge, test safety controls and record running currents before wear becomes failure. Every visit is on the calendar, so a facilities manager can plan the budget and the downtime.

The log stays with the building. It lives in a ring binder on site and as a shared PDF, with nameplate data, technician notes, replaced parts and inspection dates. It outlasts tenant leases and equipment handovers, so the next person to open the roof hatch knows what they are looking at.

Kuki Climate · Rotterdam · since 2009

Buildings

Which buildings a contract suits

All building types →

A spacious plant room with two chillers, insulated pipework and a technician small in the far background.

Plant room, an office in Kralingen, 07:40. Quarterly visit 2 of 4.

Covers

What a maintenance year covers

A technician slides a clean pleated air filter into an open commercial handling unit.

Four visits placed where the year turns: March, June, September and November. Cooling starts the year, heating takes over in November, and the log is written up every time.

  • Spring cooling start-up
  • Filter change
  • Coil and drain clean
  • Belts and bearings
  • Refrigerant check by an F-gas certified technician
  • Autumn heating changeover

4 visits a year · from €2,400

A technician points at relays inside an open controls cabinet beside the facilities manager.

Twelve visits for buildings that cannot afford a bad month: busy offices, clinics, hospitality. Everything in the quarterly year, plus a monthly reading of filters, controls and drains.

  • All quarterly items
  • Monthly filter pressure log
  • Monthly controls reading
  • Monthly drain check
  • Priority call-out for contract clients
  • Service log updated after every visit

12 visits a year · from €8,400

Survey

How the survey hour is spent

0–10

Walk the building with the facilities manager and read the existing service log, so we start from what you already know.

10–30

Roof and plant room: every unit, its nameplate and its condition, written down one by one.

30–45

Controls, filters, condensate drains and refrigerant circuits, checked while the units are running.

45–55

Notes at the table: the risks we found and what a maintenance year would cover.

55–60

Agree the next step. You decide; we book the written report.

A written report follows within 3 working days.

Request a survey hour →

A surveyor carrying a closed tablet walks between rooftop units beside a facilities manager.
Water spray rinsing dust from the metal fins of an outdoor condenser coil.
A technician on a step ladder cleans the condensate tray of a ceiling cassette unit.
Gloved hands check the fan belt tension inside an air handling unit.
Refrigerant gauge hoses connected to copper service valves on a cooling pipe.
A torch beam shines inside an open inspection hatch of a clean galvanised duct.

Log

From the service log

Halvorsen House

Office, six floors · quarterly since 2019

Six floors, nine rooftop units, quarterly since 2019 and monthly from June to August. At the spring visit the log showed a bearing running warm on unit 4. It was replaced in April, before the first hot week, and the note went into the binder.

Read the note →

Noordpoort Health Centre

Clinic, two floors · monthly since 2021

Two air handling units and six ceiling cassettes. Filter pressure is read and logged at every visit and the cassette drains are flushed on a rota, so the consulting rooms stay quiet and the readings stay comparable from month to month.

Read the note →

Maasweg Primary School

School, three rooftop units · quarterly since 2022

The March start-up and the November changeover are booked into school holidays, so no lesson is interrupted. The caretaker keeps the binder in the plant room cupboard and signs each visit before the technician leaves.

Read the note →

Prices

Contract terms and prices, excl. VAT

ItemWhat it includesPrice
Survey hour and written reportOne hour on site with the contract manager, then a written report within 3 working days. Credited to year one if you sign a contract.€190
Quarterly, up to 4 unitsFour visits a year in March, June, September and November, with the service log updated each time.€2,400 / year
Quarterly, 5–12 unitsFour visits a year for a medium plant installation: every unit tested, every reading logged.€4,800 / year
Monthly, up to 12 unitsTwelve visits a year with monthly filter pressure log, controls reading and drain check, and priority call-out.€8,400 / year
Monthly, 13–30 unitsTwelve visits a year for larger buildings that need continuous oversight and a full mechanical log.€14,800 / year
Each extra unitAdded to a quarterly or a monthly contract that goes beyond its unit allowance.€320 / €560 per year
Out-of-hours call-outFor contract clients, on the 24/7 line. Parts are charged at cost and listed in the report.€95 / hour

12-month contracts, 60 days’ notice. VAT 21% is added. Response target for contract clients: on site within 4 hours on weekdays 07:00–19:00, next morning otherwise.

Full terms →

Questions

Before you request a survey

What happens during the survey hour?

We spend 60 minutes on your roof and in your plant room with a contract manager and a technician: every unit, its nameplate and condition, the controls and the existing log. A written report follows within 3 working days.

Which area do you cover?

Buildings within 60 km of our depot at Koelhuisweg 14 in Rotterdam. If you are just outside, ask; we will say plainly whether we can serve you well.

How do out-of-hours call-outs work?

Contract clients can call the 24/7 line. The charge is €95 an hour plus parts. Our target is to be on site within 4 hours on weekdays 07:00–19:00, and the next morning otherwise.

What equipment do you maintain?

Rooftop condensers, chillers, air handling units, ductwork and ceiling cassettes in offices, shops, hotels, clinics and schools.

Who does the refrigerant checks?

Every refrigerant check and leak inspection is carried out by an F-gas certified technician, and the result is written into the service log.

Is the survey fee credited?

Yes. The €190 survey hour is credited in full against your first contract year if you go ahead.

A row of four commercial rooftop units in early morning haze over the city.

Request a survey hour

One hour on your roof and in your plant room with Leila Haddad, a written report within 3 working days. €190, credited to your first contract year.

+31 10 555 0140 · Mon–Fri 07:30–17:30

Demo · Use it free in ShipPress · Or buy without the app for US$10English · 繁體中文 · 日本語 · Français · Deutsch
Demo only: this is switched off here.